1. General Introduction
Fisher ET general purpose control valve is used for throttling or on-off control of a wide variety of liquids and gases. It is designed have single ports, balanced valve plugs,and cage guiding. Metal-to-PTFE seating for stringent shutoff requirements is standard in all valves except those with Cavitrol III cages. Metal-to-metal seating for higher temperatures is standard for valves with Cavitrol III cages. Compare to ED series, the standard temperature limits of ET valves is 204℃ can be extended to 232℃ by using PEEK anti-extrusion rings in combination with a spring-loaded PTFE seal. The PEEK anti-extrusion rings expand to close off the clearance gap between the plug and the cage where the PTFE seal may extrude at high temperatures and pressures. The temperature limits can also be extended to 316℃ for non-oxidizing service and to 260℃ for oxidizing service. It mainly come with typical features as below:
Balanced Valve Plug Construction: Balanced valve plug construction permits use of smaller, lower-cost Fisher actuators. Also, trim inventory costs are cut because dimensional standardization permits use of most standard easy-e trim parts.
Cage guide: Rugged cage guiding provides high valve plug stability, which reduces vibration and mechanical noise.
Class V or Class VI Shutoff: Higher leakage rate compare to ED series.
Multi material selectable: Carbon Steel, Stainless, Alloy
Process Connection Type: Flanged, Butt Weld, RTJ, Threaded, Socket Weld
2. Comparable table of Fisher E series Valve
Type | Guide type | Plug type | Shut off | Temperature | Soft Seat | Seal Ring | Others |
ED | Cage | Balanced | II to III | 427℃ | No | Graphite | C seal |
ET | Cage | Balanced | IV-V | 204℃ | Yes | PET | |
ES | Cage | Un-Balanced | VI | 538℃ | Yes | No | |
EZ | Cage/guide | Un-Balanced | VI | 427℃ | Yes | No | |
Notes: | 1. Dimension and pressure rating of E series valve is same, thus valves can be interchanged, but internal parts are different. | ||||||
2. E series valves are top guided type, also easy remove and change internal parts for maintenance. |
3. ET series Port Diameters, Valve Plug Travel, and Stem and Yoke Boss Diameters
Full-Sized Trim [NPS] | Port Diameter [mm] | Valve Plug Travel [mm] | Standard Stem [mm] |
1 | 33.3 | 19 | 9.5 |
1 1/2 | 33.3 | 19 | 9.5 |
2 | 58.7 | 29 | 12.7 |
2 1/2 | 73.0 | 38 | 12.7 |
3 | 87.3 | 38 | 12.7 |
4 | 87 | 51 | 12.7 |
6 | 177.8 | 51 | 19.1 |
8 | 203.2 | 76 | 19.1 |
4. Typical section drawings for ET series
Address: P.O. Box 17033, Jebel Ali Free Zone - South 2 Dubai, United Arab Emirates
Tel: +971558915937
Fax: +971558915956
E-mail:
info@rostockgroup.com
technical@rostockgroup.com
commercial@rostockgroup.com
Get the latest special offers and discount information sent to your email address.
Copyright © Rostock Group Co.,Limited All Rights Reserved. Sitemap